Stemco Standard and Grit Guard HP(TQM) User Manual download pdf

Standard/

Grit Guard

Seal

Installation

Step 1 Remove all burrs and thoroughly clean the spindle.

Apply a thin layer of No. 2 sealant to the OD of the

spindle shoulder. Place the axle ring on the spindle.

Step 2 Using the recommended Stemco Universal Axle Tool,

drive the axle ring on until the tool bottoms against the

spindle shoulder. [Photo 1] Make certain the axle ring is

flush with the shoulder. Wipe away any excess sealant.

Step 3 Remove all burrs from the hub bore and thoroughly

clean the entire wheel cavity.

Step 4 With the wheel in horizontal position, prelube

the inner bearing and place it into the bearing cup.

[Photo 2] NOTE: When using grease, pre-pack the inner

bearing before placement into the hub.

Step 5 Apply a thin layer of No. 2 sealant to the OD of the seal

and position the seal in the hub. Using the

recommended Stemco Universal Hub Tool held in a

vertical position, drive the seal into the seal bore until it

is bottomed-out. [Photo 3] Check the clearance between

the bearing cone and seal (at least 1/32” is required).

Step 6 With the wheel mounted on a dolly, carefully align the

bore with the spindle. [Photo 4] Gently push the wheel

assembly onto the spindle to the proper position. Pre-

lube the outer bearing and push it into the bearing cup.

Step 7 Assemble the inner nut and tighten it to 200 ft/lbs.

[Photo 5] Rotate the wheel several times and then back-

off nut one full turn. Make final bearing adjustment

according to TMC recommended bearing adjustment

procedure. Install the appropriate axle fastener.

Step 8 Install the hub cap with the new gasket and fill the

cavity to the proper oil level as indicated on the window.

On drive axles, be sure the differential oil level is high

enough (manufacturer’s recommended level) to ensure oil

flow through the tube to the wheels. It is recommended

to jack-up one side and then the other until flow starts.

Make certain the breather plug is clear. Recheck steers

and trailers to insure proper fill levels.

INSTALLATION

www.stemco.com

1-800-527-8492

INSTALLATION 1

Summary of Contents

Page 1 - INSTALLATION

Standard/Grit Guard®SealInstallationStep 1 Remove all burrs and thoroughly clean the spindle.Apply a thin layer of No. 2 sealant to the OD of thespind

Comments to this Manuals

No comments

Stemco Standard and Grit Guard HP(TQM) User Manual

Browse online or download User Manual for For the car Stemco Standard and Grit Guard HP(TQM). STEMCO Standard and Grit Guard HP(TQM) User Manual

Summary of Contents

Comments to this Manuals

Related products and manuals for For the car Stemco Standard and Grit Guard HP(TQM)