Stemco Aeris Pre-Prep Axle User Manual download pdf

STEMCO Aeris Pre-Prep Axle Installation

Part Number: 01-571-xxxx

Date: 7/27/2012

Axle Hose Installation

• Insert the airline fittings into the outer most tapped holes on the axle and tighten.

• Place a piece of masking tape (or equivalent) over the end of the air line or plug the end of it

so no debris can get inside the line as it is being pushed through the axle towards the wheel

end.

• Route the airline tubing through the fitting body and help feed it towards the end of the axle

until 6-8” of airline tubing is sticking out the spindle end. Make sure the airline doesn’t have

any kinks in it. You will need to put the grommet and the nut on the tubing before you start

feeding it through the air fitting body. Hand tighten the nut and grommet on the fitting.

• Repeat procedure on other end of axle. Make sure when feeding airline tubing into axle it

heads towards the correct spindle end.

• A continuous “loop” of tubing should span between the two fittings.

Flexible Conduit Airline Protection Installation

• Place a piece of flexible conduit over tubing of each spindle end to help protect against sharp

edges of axle.

Center Vent Line Fitting Installation

• Install the push lock fitting (1/4” NPT x 3/8” tubing) into the center tapped hole and tighten.

• Install plastic protective cap over Axle Vent Fitting (to be supplied by Stemco).

AXLE VENT

FITTING

1 2

STEMCO Aeris Pre-Prep Axle Installation Part Number: 01-571-xxxx Date: 7/27/2012 Axle Hose I

Page 2

Axle Plug Installation • Install the axle plug using the axle plug installation tool. The hose goes through the center of the axle plug which is th

No comments

Stemco Aeris Pre-Prep Axle User Manual