Stemco 610-0025 Hubodometer User Manual download pdf

Printed in the USA

(Hudson 10-491) 09-611-0036

Rev. 07-05

ISO 9001:2000 & ISO/TS 16949

STEMCO-USA • P.O. Box 1989 • Longview, TX 75606-1989

(903) 758-9981 • 1-800-527-8492 • FAX: 1-800-874-4297 • www.stemco.com

STEMCO-CANADA • 5900 Ambler Drive, Units 4 & 5 • Mississauga, ON L4W 2N3

(905) 206-9922 • 877-232-9111 • FAX: 877-244-4555

Installation Instructions

for STEMCO Hubodometer

Rear Wheel Truck or Bus Mount

Part Numbers 610-0011 and 610-0025

IMPORTANT: HUBODOMETER

MUST BE ACCURATELY CENTERED ON WHEEL.

1. Drill two 3/16" holes on each end of mounting strap (#1) at marks corresponding to bolt circle diameter

of rear wheel axle (#2).

2. Open single hole in support angles (#3) if necessary to fit axle studs or bolts.

3. Cut and trim strap 3/8" beyond rivet holes on both ends.

4. Assemble angles (#3) to mounting strap (#1) as per drawing, using 4 rivets (#4) supplied. Trim angles to conform

to contour of axle if necessary.

5 IMPORTANT: Place washer (#7) on Hubodometer

stud.

6. Mount Hubodometer

(#6) on strap using 1/2" locknut (#5) supplied. It is recommended that a strap wrench be

used to hold Hubodometer

while tightening. Do not clamp Hubodometer

flange in a vise. Do not exceed

15 ft/lbs torque.

7. Mount strap assembly to axle.

8. To clean Hubodometer

face, use a damp cloth to prevent scrathes. Do not use solvents, paints or thinners.

10-491 Hubodometer Install 7/19/05 3:11 PM Page 1

Printed in the USA(Hudson 10-491) 09-611-0036Rev. 07-05ISO 9001:2000 & ISO/TS 16949STEMCO-USA • P.O. Box 1989 • Longview, TX 75606-1989(903) 758-9

Related models: 610-0011 Hubodometer

No comments